Eneo EDMC-3221B - Manual (Page 25)

20
4. After aiming the camera (view direction and lens control), release the CTRL key. The cursor
will be on the “TITLE” after saving data then twist the Joystick or press the Tele or Wide key
to edit the Preset title. Follow the procedure of the Auto Scan above to edit titles.
5. Select “CAMERA SET” and push the Joystick to the left or right. Then the Preset camera
setup displays.
PRESET CAMERA SETUP
FOCUS : AUTO
MOTION : OFF
MOTION SETUP
AE SETUP
SAVE AND EXIT(ESC TO CANCEL)
Set FOCUS : AUTO, MANUAL, ONE PUSH
Set MOTION : OFF, ON
Select “MOTION SETUP” and pushing the Joystick to the left or right. Then the MOTION
setup displays.
MOTION SETUP
SENSITIVITY : 06
POSITION : ALL
DELAY : 00 SEC
OUTPUT : OFF
HOLD TIME : 03 SEC
EXIT(ESC TO EXIT)
Set SENSITIVITY : 01 ~ 10
Set POSITION : ALL, CENTER
Set DELAY : 00 ~ 05 SEC
Set OUTPUT : OFF, ON
Set HOLD TIME : 03 ~ 99 SEC
Select “AE SETUP” and push the Joystick to the left or right. Then the AE setup displays.
Refer to the AE SETUP in the camera setup.
6. Set “DWELL TIME”. (03 ~ 99 seconds)
7. To select the next page of Presets, scroll the page by pushing the Joystick to the left on the
first and last columns of the menu.
8. Repeat step 2 through 7 for each additional Preset position.
9. Select “SAVE AND EXIT” and push the Joystick to the right or press the IRIS Open key.
Press the ESC or IRIS Close key to exit the program without saving.
NOTE: Press the HOME key at programmed Preset position(*) to delete a programmed
Preset view.