Eneo EDMC-3221B - Manual (Page 34)

29
3.13 Dome Setup
CONFIGURATION MENU
LANGUAGE : ENGLISH
HOME FUNCTION SETUP
OSD DISPLAY
VIEW ANGLE SETUP
INITIALIZE DATA
ORIGIN OFFSET
DOME RESET
SYSTEM MENU
SYSTEM INFORMATION
SAVE AND EXIT(ESC TO CANCEL)
• LANGUAGE SETUP
LANGUAGE : Select the desired language.
• HOME FUNCTION SETUP
HOME FUNCTION SETUP
HOME FUNCTION : NONE
FUNCTION NUMBER : ---
WAITING TIME : 120 SEC
FUNCTION ENABLE : OFF
SAVE AND EXIT(ESC TO CANCEL)
HOME FUNCTION : None / Tour / Pattern / Auto Scan / Preset
FUNCTION NUMBER : - - -
WAITING TIME : 10 ~ 240 seconds
FUNCTION ENABLE : ON / OFF
The Home function can be set so that the camera automatically goes to Tour, Pattern,
Auto Scan or Preset after the keyboard controller has been idle for a specified amount of time.
For example, if the controller is idle for 120 seconds, the camera goes to Preset 1.
Follow these steps to program the Home position:
1. Select “HOME FUNCTION” by pushing the Joystick to the left or right to scroll through the
None, Tour, Pattern, Auto Scan or Preset functions.
2. Select “FUNCTION NUMBER” and push the Joystick to the left or right. The recorded
function number will scroll.
3. Select “WAITING TIME” and push the Joystick to the left or right to select from 10 to 240
seconds.
4. Select “FUNCTION ENABLE” and turn to ON or OFF by pushing the Joystick to the left or
right.