Eneo EDMC-3221B - Manual (Page 26)

21
The position, which is marked with the *, already has the Preset view assigned. Press the PRST
key on the * to review the stored Preset. The camera will show the stored Preset scene.
PRESET AREA SETUP
(CTRL KEY)
NUMBER 001
PAN TILT
000.0 000.0
EXIT(ESC TO EXIT)
Hold down the CTRL key while selecting the desired scene using the Joystick. Current position
will be displayed. Release the CTRL key to complete. Or Press the IRIS Open key then the
“CTRL” displays. Move the desired position and the zoom position. Press the IRIS Close key
then the “CTRL” disappears. Select “EXIT” and push the Joystick to the right.
3.6 Shortcut of Preset Program
After selecting the desired scene, press No. (1 to 240), and press the CTRL and PRST keys
subsequently. The current view will be stored to the selected Preset number if the Preset number
is empty. If selected Preset number is not empty, “OVER WRITE” message will be displayed on
the monitor and select the “OK” and push the Joystick to the right to overwrite.
Example: 1 , 0 , 1 + CTRL + PRST keys will store current view as Preset no. 101. In this case,
focus will be programmed as Auto, dwell time will be set to 3 second, and the current
AE mode will be programmed.
3.7 Tour (Shortcut: TOUR)
There are 8 programmable Tours. Each Tour consists of up to 42 Preset positions, Patterns,
Scans or other Tours (second-level). Using second-level Tours, it can be expanded to over
300 functions in a single Tour.
TOUR SETUP
NUMBER : 01
TITLE : T01
SCAN TYPE : NORMAL
SPEED : 5 STEP
DWELL : -- SEC
003 A04 --- --- --- --- ---
--- --- --- --- --- --- ---
--- --- P01 --- --- --- ---
--- T02 --- --- --- --- ---
--- --- --- --- --- --- ---
--- --- --- --- --- --- ---
SAVE AND EXIT(ESC TO CANCEL)
--- : blank position
SCAN TYPE : NORMAL, VECTOR
DWELL : 03 ~ 99 SEC
003 : Preset (1 ~ 240)