H3C Technologies H3C SecCenter UTM Manager - Manual (Page 10)

2
Installation and uninstallation
Installing H3C SecCenter
Installing H3C SecCenter installs all H3C SecCenter components at the same time.
H3C SecCenter runs on Windows. The detailed software and hardware requirements are as follows:
• Hardware: P4 2.0 CPU or above, 1.5G memory or more, 80G disk or more.
• Operating system: Windows 2003 Server (recommended) or Windows XP, installed with the
up-to-date patches.
• Browser: IE 6.0 or above
To install H3C SecCenter, run the executable file install.exe, which is under the installation directory, and
proceed as prompted. During installation, pay attention to the following steps:
1. On the language selection page, select English from the language dropdown list as shown in
Figure 1 , and click OK to continue.
Figure 1 Select the language for SecCenter
2. On the SecCenter server port page, type a port number or leave the default port number 80
unchanged and click Next to continue, as shown in
Figure 2 .