Grass Valley CopperHead PowerWafer - Manual (Page 24)

20
CopperHead System Components
Base Station Rear Panel
Fig. 3-8: AC Mains Connector
• 20: AC Power Receptacle 100-240V 50/60 Hz
• 21: 3.15 amp dual fuse assembly
Two 4 amp fuses (5 x 20mm).fuses are in operation at all times – both the AC Line Hot
and the AC Line Neutral are fused.
• 13: For Future Use (RJ45)
Rear Panel Section B - Optical Connector
The fiber optic connector is used to connect Base Station directly to Camera Unit or to the
external MPS or HDX power supply configured with your system. The type of fiber
connector will vary depending on your system configuration. Six types of fiber optic
connectors are available for use with the CopperHead Base Station.
Rear Panel Section C - Signal Connectors
Fig. 3-9: Rear Panel Signal Connectors
• 5: Connector for Camera Remote Control Panel and Tally input (DB15HD)
Connect CHBR-PRO cable here, specified for your particular Camera Remote Control
Panel.
"Dry" (unpowered) fiber connectors Fiber Connectors with Copper for Power
A: OpticalCON
(dry)
B: STs C: MX D: OpticalCON
(powered)
E. SMPTE 304M F. STs & Molex