Grass Valley CopperHead PowerWafer - Manual (Page 8)

4
About CopperHead PowerWafer
Safety and Fiber Optic Systems
Safety and Fiber Optic Systems
Optical Fiber Safety
Never look directly into the end of the optic fiber while either end of the system is
operating.
Always use cable connector caps when the cables are not connected. This protects the
connector from damage and the unlikely event of exposure to an operating optical link.
Keeping the caps in place when the connectors are not in use will prevent dirt and dust
from entering the connector and degrading the performance of the optical link.
Power Fuses
The CopperHead PowerWafer Base Stations CHG3-BS-3050-95VD-xxx-xxx are equipped
with two fuses located next to the AC Power receptacle at the left rear of the unit. Refer to
Connectors and Accessories on page 37 for specific fuse and location information.
NEVER operate the CopperHead CHG3‐BS‐3050‐95VD‐xxx‐xxx Base Station without
properly installed and rated fuses. Severe electrical and heat damage could result as well
as personal injury or death.