Grass Valley 2200 - Manual (Page 45)

3-21
Write Wipe Pattern (C8) Command
Write Wipe Pattern (C8) Command
The Write Wipe Pattern command selects the speciÞed primary or secondary wipe
pattern for an M/E. Only one primary and one secondary wipe pattern can be
active at a time for each M/E.
Table 3-13. Write Wipe Pattern Command
Effects Addresses
Valid effects addresses for the Write Wipe Pattern command are:
EFFECTS ADDRESS ASSIGNMENTS
01 Mix/Effects 1 System
02 Mix/Effects 2 System
03 Mix/Effects 3 System
Wipe Numbers
Wipe numbers range from 00H to 41H, corresponding to decimal numbers 0
through 65 on the Wipe subpanel. Specifying an invalid wipe number can produce
unexpected results.
The format of the Wipe Number byte is as follows:
The seven least signiÞcant bits (W W W W W W W) represent the wipe number in
hexadecimal.
When the P/S bit is a 0, the editor selects a Primary Wipe Pattern; however, when
the P/S bit is a 1, the editor selects a Secondary Wipe Pattern.
Please note that Wipe Pattern number 59, ÒExternal,Ó can be used only with a
Secondary Wipe Pattern selection.
Function
Byte
Count Effects
Address Command
Code
Message
Write Wipe Pattern 03 EX C8 (Write) Wipe #
Bit Bit
7 6 5 4 3 2 1 0
P/S W W W W W W W