Grass Valley UniConfi NVISION Series v.1.3 - Manual (Page 117)

UniConfig Configuration Application • User’s Guide 105
11. Managing Machine Control Ports
Setting Machine Control Take Preferences
If a machine control router is in ‘Data X/Y’ mode, when a ‘take’ is performed, only one signal is
passed. For example, if a ‘take’ is performed for port 1 to port 2, one signal is passed from 1 to 2,
not 2 to 1. This allows another ‘take’ to be performed without removing prior path connections. For
example, a ‘take’ for port 1 to port 4, passes one signal from 1 to 4 without disconnecting the signal
of path of 1 to 2.
How to Set Machine Control Take Preferences
1 Launch UniConfig. (See Launching UniConfig on page 9.)
2 From the menu bar, select ‘Window > Connections’. The ‘Connections’ window appears with
blank fields:
Figure 11-2. Example of Connections Window with Machine Control Tab in Front
The ‘Connections’ window must be active to activate the necessary menu bar options.