HEIDENHAIN SW 54843x-03 - Manual (Page 264)

264 Cycle programming
4.5 Recessing cy
cles
Undercutting type H
Call the recessing cycles
Select undercutting H
The contour depends on the parameters defined. If you do not define
an undercut radius R, the oblique cut will be executed up to contour
corner Z1
(tool radius = undercut radius).
If you do not define the plunge angle, it is calculated from the
undercut length
and undercut radius. The final point of the undercut
is then located at the contour corner.
The end point of the undercut is determined from the plunge angle in
accordance with Undercut type H.
Cycle parameters
X, Z
Starting point
X1, Z1 Corner point of contour
K Undercut length
R Undercut radius (default: no circular element)
W Plunge angle (default: W is calculated)
G47 Safety clearance (siehe Seite 142)
G14 Tool change point (siehe Seite 142)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
MT M after T: M function that is executed after the tool call T.