HEIDENHAIN SW 54843x-03 - Manual (Page 446)

446 ICP programming
5.13 Lat
er
al surf
ace cont
ours in smar
t.T
u
rn
Circular pattern on lateral surface
Reference data: (siehe „Reference data of lateral surface” auf Seite
437)
Reference data of lateral surface
ID
Contour name
PT Milling depth
XR Reference diameter
Parameters of pattern
Z
Center of pattern
CY Center of pattern as linear dimension (reference: diameter XR)
C Center of pattern (angle)
QP Number of points in pattern
DR Direction of rotation (default: 0)
 DR=0, without EP: Figures are arranged on a full circle
 DR=0, with EP: Figures are arranged on the longer circular
arc
 DR=0, with EPi: The algebraic sign of EPi defines the
direction (EPi<0: clockwise)
 DR=1, with EP: clockwise
 DR=1, with EPi: clockwise (algebraic sign of EPi has no
effect)
 DR=2, with EP: counterclockwise
 DR=2, with EPi: counterclockwise (algebraic sign of EPi has
no effect)
DP Pattern diameter
AP Starting angle (default: 0°)