HEIDENHAIN SW 54843x-03 - Manual (Page 40)

40 Introduction and fundamentals
1
.2 Configur
ation
The C axis
With a C axis you can drill and mill a workpiece on its face and lateral
surfaces.
When the C axis is used, one axis interpolates linearly or circularly with
the spindle in the given working plane, while the third axis interpolates
linearly.
The MANUALplus supports part program creation with the C axis in:
 Teach-in mode
 smart.Turn programming
 DINplus programming
The Y axis
With a Y axis you can drill and mill a workpiece on its face and lateral
surfaces.
During use of the Y axis, two axes interpolate linearly or circularly in
the given working plane, while the third axis interpolates linearly. This
enables you to machine slots or pockets, for example, with plane
floors and perpendicular edges. By defining the spindle angle, you can
determine the position of the milling contour on the workpiece.
The MANUALplus supports program creation with the Y axis in:
 Teach-in mode
 smart.Turn programs
 DINplus programs