HEIDENHAIN SW 688945-03 - Manual (Page 389)

HEIDENHAIN CNC PILOT 620/640 389
6.5 Editing ICP cont
ours
Editing contour elements
The CNC PILOT provides various ways to change an existing contour.
The procedure is illustrated in the following example of editing the
length of an element. The other functions work similar to the
procedure described here.
The following editing functions are available for existing contour
elements.
 Trimming
 Length of element
 Length of contour (only for closed contours)
 Radius
 Diameter
 Change
 Contour element
 Form element
 Delete
 Element/Range
 Move element/range as well
 Contour/Pocket/Figure/Pattern
 Form element
 All form elements