Yaskawa V1000 Option Dual Port EtherNet/IP SI-EN3D/V Technical Manual - Manual (Page 45)

Instance
ID
Attribute Name Description Get Set Size Range Default
1 11 Warning
Warning
0: No Warning
1: Warning
O – Byte – 0
1 12 Fault Reset
Fault Reset
0: No Fault Reset
1: Fault Reset
O O Byte 0, 1 0
1 13 Fault Code
Current Fault
Refer to Option Fault Code
Conversion Table on page 45 for
details.
O – Word – 0000
1 15
Control from
Net (Status)
Run Command from the option
0: The Run command is not from the
option
1: Enables the Run command from
option
O – Byte – 0
1 16 NetFaultMode Normal 2 (Vendor Specific) O – Byte – 2
1 17 Force Fault
External Fault
0: No External Fault
1: External Fault (EF0)
Triggered by the rising edge of the
signal.
O O Byte 0, 1 0
1 18 Force Status
External Fault status
0: No External Fault
1: External Fault (EF0)
Triggered by the rising edge of the
signal.
O – Byte – 0
n Option Fault Code Conversion Table
Drive Fault Code (Hex)
(MEMOBUS/Modbus 0080 Hex)
Option Fault Code (Hex) Description
2 3220 DC Bus Undervolt (Uv1)
3 5110 CTL PS Undervolt (Uv2)
4 3222 MC Answerback (Uv3)
5 2130 Short Circuit (SC)
6 2120 Ground Fault (GF)
7 2300 Over Current (oC)
8 3210 DC Bus Overvolt (ov)
9 4200 Heatsink Overtemp (oH)
10 4210 Heatsink Max Temp (oH1)
11 2220 Motor Overload (oL1)
12 2200 Drive Overload (oL2)
13 2221 Overtorque Det 1 (oL3)
14 2222 Overtorque Det 2 (oL4)
15 7110 DynBrk Transistor (rr)
16 7112 DynBrk Resistor (rH)
17 9000 External Fault 3 (EF3)
18 9000 External Fault 4 (EF4)
19 9000 External Fault 5 (EF5)
20 9000 External Fault 6 (EF6)
21 9000 External Fault 7 (EF7)
27 3130 Input Phase Loss (PF)
28 3130 Output Phase Loss (LF)
29 5210 Motor Overheat 1 (PTC Input) (oH3)
30 5300 Operator Disconnected (oPr)
31 6320 EEPROM R/W Error (Err)
32 3210 Motor OverHeat 2 (PTC Input) (oH4)
10 General Class Objects
YASKAWA SIEP YAICOM 15A V1000 Option Dual-Port EtherNet/IP SI-EN3D/V Technical Manual 45