Setting program start time(s) – Irritrol IBOC-Plus User Manual
SETTING PROGRAM START TIME(S)
This procedure is used to set the watering cycle start time(s) for each
program. A maximum of eight start times per program can be assigned.
Each start time will initiate a sequential watering cycle of all stations
with an assigned run time in the program.
Note: It is important to remember that a start time initiates the entire
watering program cycle, not an individual station.
The Program Looping feature enables a watering program to start and
run consecutive repeat cycles until a predetermined stop time is reached.
Each program can have one loop operating cycle assigned in addition to
eight regular start time assignments. If a program loop is not assigned, the
display shows “Loop Strt Off.”
To set program cycle start times and/or program loop time:
1. Turn the function dial to the
PROGRAM CYCLE START TIMES/
2. Select Program
3. Use the +/
button to adjust the start time hour.
4. Press the
button to select the minutes digits.
5. Use the +/
button to adjust the start time minutes.
Note: To remove a start time, adjust the time to display “Off”
which is located between 11:59 p.m. and 12:00 a.m.
6. Press the
button and repeat steps 3 through 5 to assign up to
eight start times for the selected program.
7. Press the
button to display “Loop Strt.”
8. Use the
button(s) to adjust the loop time hour.
9. Press the
button(s) to adjust the loop time minutes.
11. Press the
button to display “Loop Stop” and repeat steps
8 through 10 to set the loop stop time.
12. Repeat steps 2 through 11 for each program as necessary.
13. When finished, return the function dial to
Programming the Controller