KACO blueplanet gridsave eco 5.0 TR1 - Manual (Page 17)

Installation and startup
Operating instructions for blueplanet-gridsave eco_EN Page 17
Authorised electrician
6 Installation and startup
DANGER
Risk of fatal injury from fire or explosions
Fire caused by flammable or explosive materials in the vicinity of the device can lead to serious
injuries.
› Do not install the device in areas where there is a risk of explosion.
› Do not install the device in the vicinity of highly flammable materials.
› Do not install the device over a battery.
› Do not install in the vicinity of electrolytes and corrosive aerosols.
6.1 Installation location
Installation space
• Restrict access by unauthorised personnel,
• As dry as possible, well ventilated, and it must be possible to convey the waste heat away from the device
• Unobstructed air circulation,
• Accessible from the front and sides without requiring additional resources,
• Do not install the device or the corresponding batteries in a damp area,
• Protect against direct sunlight and direct water contact,
• For easy operation, ensure during installation that the display is slightly below eye level.
• Observe local regulations when installing in combination with a battery.
Wall
• With sufficient load-bearing capacity,
• Accessible for installation and maintenance,
• Made from heat-resistant material (up to 90 °C),
• Flame resistant,
• Minimum clearances at the installation and assembly location. (See Figure 7 on page 19)
NOTE
Access by maintenance personnel for service
Any additional costs arising from unfavourable structural or mounting conditions shall be billed to
the customer.
CAUTION
Risk of chemical burns!
› Disconnecting a live DC connection can cause a dangerous arc which could result in hot and corro-
sive particles arising from the battery This could cause irreversible health damage.
› Only trained and qualified electrical personnel are permitted to remove connections from battery
cells in line with appropriate procedures and safety precautions.
› Observe the safety instructions from the battery manufacturer.