KACO blueplanet gridsave eco 5.0 TR1 - Manual (Page 29)

Configuration and Operation
Operating instructions for blueplanet-gridsave eco_EN Page 29
8.1.1 Display of status and fault messages
Item Meaning LED Status Description
1 Generator
status
Status LED displays generator operation:
• No generator control
• Generator starting
• Generator running
• Generator cannot start automatically
• Generator fault
Off
Green flash-
ing green
Yellow flash-
ing
Red flashing
2 AC source Blue Input of external alternating voltage from
• generator or
• power grid
3 Transfer Off
Blue
Alternating voltage outside tolerance range for synchronisation
External alternating voltage connected to AC load output.
(The status LED flickering is normal)
4 Consumer (AC
load)
Blue Consumers are supplied with AC voltage. (Display also possible
without DC connection on the device)
5 Power mode Status LED displays device operation:
• Device in no-load operation. Monitoring and data acquisition
active
• Device is active in save mode and measures the load condi-
tions
Green
Slow flashing
in green
Fast flashing
in green
• Device is preparing to start.
Green
Red flashing
• Device is switched on
• Interrupted power circuit or poor battery connection > no out-
put of inverter power possible
Red • Fault detected
6 Export Green Energy is exported to the grid with on-grid plant
Flashing in
green
• AC load is supplied
7 Battery status Display of the battery voltage (standard) or charge status.
With active SoC control, the proportion of usable residual charge
in the batteries is displayed. The usable charge is between 100 %
SoC and the shutdown SoC.
upper
range
Green Display of the trickle voltage or higher voltage
Red • Immediate shutdown due to high DC voltage
lower
range
Yellow • Battery weak
Red flashing • Immediate shutdown due to low DC voltage
Red • Shutdown due to weak battery
Show all Red flashing • Shutdown if low battery voltage is removed !
In the case of an emergency, the operation of the device can
be maintained at reduced power via the battery shutdown
limit through to complete discharge.
This emergency function may damage the battery and the
connected devices, however!