Lanner FW-8771 - Manual (Page 15)

10
Hardware Setup
Chapter 2
Network Application Platforms
For front Ethernet module riser card installation (model
FW-8771C only), order the Riser Card Kit RC-87712 and use
the following procedure:
Remove the pre-installed riser card RC-87711. 1.
Align the divider of riser card RC-87712 with the slot 2.
key on the socket.
Press the card to insert the card into the socket until it
3.
installs firmly. Secure the card with 4 screws.
Front Ethernet Module Installation
To install the front Ethernet module, take off the front 1.
bezel first by unfastening the thumbscrews on the
front of the bezel.
Insert the Ethernet module into the front expansion
2.
slot. You should hear a click when the module connects
to the system’s mainboard.
Secure the Ethernet module by fastening the
3.
thumbscrews on the module. (Using a screw driver is
highly recommended.)