Casio DT-X10 - Manual (Page 40)

E-38
1 USB Port
2 RS-232C Port
3 RS-422C Port
4 AC Adaptor Jack
5 Wall Mount Unit
Fastening Plate
6 Terminal Detect
Switch
7 IR Port
8 Power Contacts
9 Power Indicator
Lamp
10 Communication
Indicator Lamp
11 System Status
Indicator Lamp
12 Power Switch
13 Desktop Unit
14 DIP Switches
This port accepts connection of a USB cable for connection to a
computer for transfer of system data and file data. Use of the
USB port requires installation of a special driver on the PC.
This port accepts connection of an RS-232C cable for
connection to a computer for transfer of system data and file
data. Use of the RS-232C port requires installation of a special
driver on the PC.
This port is used when connecting to another Bridge Satellite
Cradle.
Connect the AC adaptor here.
The holes in this plate accept screws that secure the wall mount
unit in place.
This switch detects when the Handheld Terminal is not seated
correctly on the Bridge Satellite Cradle.
This port transfers data with the Handheld Terminal IR port non-
contact data communication.
Power is supplied to the Handheld Terminal via these contacts.
This lamp indicates the Power Status and the mounting status of
the Handheld Terminal.
Off: Power off
Green: Power on, Handheld Terminal mounted correctly
Red: Power on, Handheld Terminal not mounted
This lamp shows when the Handheld Terminal is performing
data communication.
Off: No data communication being performed
Green flashing: Data communication in progress
Red: Problem with a connection between two Bridge Satellite
Cradles
This lamp indicates whether the system is operating normally.
Regardless of whether or not a Handheld Terminal is mounted
this lamp indicates the system status and whether or not a
communication operation with the system can be performed.
Off: System is not operating.
Green: System is operating.
Turns the power on and off.
This is the base when using the Bridge Satellite Cradle in a
desktop configuration. Remove the desktop unit in the case of a
wall-mount configuration.
Use these switches to configure the Bridge Satellite Cradle as
required.
DT-X10_E_P37_52.p65 05.4.1, 11:04 AM 38