Enviro Westport C-10381 - Manual (Page 37)

37
Figure 63: Top brick panel in place, screws shown. Figure 64: Back brick panel in place.
Figure 65: Side brick panels in place.
Figure 62: Brick panel bracket, slots shown.
1. Remove the two (2) screws from the
rear of the baffle, use a ¼” socket
or a flat head screwdriver. Place the
provided brick bracket (Figure 62) at
the rear of the baffle with the slots
over the screw holes (see Figure 63).
Insert two (2) of the provided screws
into the two (2) holes along the
bottom of the baffle.
2. Remove the two (2) screws from the front of the
baffle. Slide the top brick panel into the bottom
bracket and place the other brick bracket over the top
of the panel and line up the slots on the bracket with
the holes at the top of the baffle. Use two (2) of the
provided screws to hold the bracket in place. Ensure
the top panel is centered before tightening the four
(4) screws completely (refer to Figure 63).
3. Slide the bottom brick panel into place under/behind
the top panel bracket, the notched side is to rest on
the firebox bottom. The panel should rest flush with
the back of the firebox (refer to Figure 64).
4. Slide each side brick panel into place along the sides
of the firebox. The panels should rest flush with the
back panel and the sides of the firebox (refer to
Figure 65).
Secondary Installation
i
nstaLLation oF
P
aneL
s
et
:
Do not install when the unit is hot.
The brick panel set is fragile. Handle panels with care and avoid knocking them on the
placement pins or any other object.