MCZ Vivo 80 Pellet Comfort Air - 2012 - Manual (Page 48)

2
4
3
1
46
8-MAINTENANCE AND CLEANING
CLEANING THE SMOKE DUCT AND FITTING
When the product is extracted, you can intervene on the smoke fan (1) from the left side for cleaning and maintenance purposes. Clearly,
the smoke evacuation fan must be removed for such maintenance to be performed.
A gasket (3) is applied on the fan outlet, which guarantees the tightness with the smoke fitting (2). Always verify that this gasket is
intact and if necessary, replace it. The gasket can also be adjusted via a screw. The pressure on the fitting can be increased or decreased
by loosening the screw.
The flue connection to its ash collection compartment (4) is located in the rear/lateral part of the product, in line with the fan outlet. Also
clean this compartment with a vacuum cleaner by inserting the nozzle on the fan inlet hole.
Then clean the smoke exhaust, especially around the fittings, curves and any horizontal sections. For information on cleaning the flue,
contact a chimney sweeper.
ATTENTION! The frequency with which the smoke exhaust must be cleaned depends on the use of the product and
the type of installation.
OTHER CHECKS
All the tightness gaskets fitted on the components on which maintenance is to be performed (smoke evacuation fan,
inspection sections, etc.) must be replaced when these are removed for maintenance purposes. Verify the tightness of the gaskets on the
hearth door and if necessary, contact an authorized service centre for them to be replaced.
The company recommends contacting an authorised service centre for end-of-season maintenance and cleaning as the above-mentioned
operations will be performed together with a general inspection of the components.
1 = SMOKE EXHAUST FAN
2 = SMOKE FITTING
3 = GASKET
4 = ASH COLLECTION COMPARTMENT