RISCO Group Orbit Pro RP-296 - Manual (Page 20)

user manual 12
ARMING YOUR SYSTEM
STEP DESCRIPTION
1 Check the READY LED on your keypad. If lit or flashing,
the system is READY.
If NOT lit or flashing, the system is NOT ready to be armed.
Secure or bypass the violated zone(s) and then proceed.
2 Choose among one of the following arming types:
3
Arming when Leaving the Premises Empty:
Enter your User Code and press [ARM] key
NOTE: If you make a mistake the keypad will produce three
short beeps. If so, press (44) quickly and re-enter the above
sequence correctly
If your system has Quick Arming, simply press .
4
All persons are to exit except the person arming the system.
Leave the premises and close the door. The keypad will beep
as counts down the Exit Delay period, and the ARM LED
flashes for the above duration, and than light steadily.
If LCD KP is in use, its display will indicate the remaining Exit
Delay time, at the end of this period, it displays
ARMED.
3 Arming with the Premises Occupied
Enter your User Code and press [STAY] key
If your system has Quick Arming, simply press .
Note: Pressing [STAY] twice will cancel the entry delay time.
Pressing [4] during exit time will silence the beeps on the
keypad.
4
If required, leave the premises and close the door. The keypad
will beep as it counts down the Exit Delay period, and the ARM
LED flashes for the above duration will than light steadily. The
BYPASS LED will light, indicating that the interior zones are
being bypassed.
If LCD keypad is in use, its display will indicate the remaining
Exit Delay time, and at the end of this period, it displays
AT
HOME ARMED.