Rosen Aviation 1060 Series : 10.6 inch WideScreen High definition - Manual (Page 18)

Rosen Aviation 10.6” HD Widescreen Bulkhead Display
Document Number: 106282 Revision: D
Date: 03/20/14
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 18 of 30
6.1. Advanced Technician Submenu
This submenu provides installers and technicians more advanced controls of the image. The
active video signal and the Mode MenuOperation Mode setting determine which options will
appear in the Technician Advanced submenu.
Figure 19 Technician Advanced submenus
6.1.1. Factory Reset
Choose this option to perform a complete factory restore. It is similar to Reset Scheme in
the Main MenuAdvanced submenu; however, Factory Reset returns all options with
pre-determined defaults in both the User and Technician menus to their factory default
settings.
Highlight AdvancedFactory Reset and press ENTER.
A Reset Complete message appears after the display restores the default settings. A
Factory Reset will not change the
Operation Mode (Auto Detect/Standard).
6.1.2. Comp/RGB 1
Use Comp/RGB 1 to specify which signal type the Component/RGB channel 1 will
accept. The options for channel 1 to display are either Component or RGB 1.
(Comp/RGB1 is available when you set the Operation Mode to Standard.)
Highlight AdvancedComp/RGB 1 and press ENTER.
Use the ▲▼ buttons to set the option, and then press ENTER.
Select Back to return to the Technician Menu.
Press EXIT when you are ready to exit the OSD.
The only options
available with SDI
active
Additional options
available with
Composite active
Auto Detect mode (default) Standard mode
Not
available