Whelen SABKT1 - Manual (Page 3)

Page 3
DRIVERS SIDE
FRONT OF VEHICLE
Fig. 2 Mounting area shown with
Battery and tray plus air filter and
filter housing removed. The siren
will mount in this area.
Fig. 3 Mark location of
the top edge of
the bracket.
Fig. 1
The top view of the bracket
shows which holes to use
for this application
Use these
holes for this
application.
MOUNTING
AREA
5/16 SPLIT
L O C K
WASHER
5/16 - 18 X 1
HEX HEAD BOLT
FIG. 1
FIG. 2
5/16 - 18
1/2" DIA.
HEX NUT
Installation / 2001 Ford Taurus:
READ BEFORE INSTALLING: The speaker will mount in the area
usually occupied by the air bag system. If your vehicle is equipped
with A.B.S. you can not mount the speaker in this location.
For this appication, the speaker will mount under the battery tray. First you
will need to remove the battery and tray, and the air filter and housing (Fig.
2). The speaker bracket will mount to the drivers side of the engine
compartment, on the side wall.
1. Disconnect the ground on the battery, remove the battery and tray
and then remove the air filter and housing.
2. Attach the speaker to the bracket (Fig. 1). An SA314 is shown. See
page 2 for an SA315.
3. Position the bracket (with speaker) onto the mounting area. Do not
position it so far forward that the speaker is muffled. Be sure the
bracket doesn’t interfere with any existing vehicle components. Using
the bracket as a template, mark the mounting surface where the
mounting screws will be located.
Note: Do not allow the new mounting hole locations to be directly
adjacent to any existing holes.
4. Remove the speaker from the bracket. Using the self-tapping screws
and washers supplied, mount the bracket onto the vehicle.
Note: You will need to drive the self tapping screws in with a socket
attached to a drill.
5. Remount the speaker to the bracket making sure that the speaker
wires exit the bottom for proper drainage .
6. Extend the WHITE (Positive) and BLACK (Negative) speaker wires to
your siren amplifier and connect as shown in the amplifiers
instructions.
Installation / 2004-05 Dodge Durango:
1. First you will have to remove the grill. To remove the grill, you first
have to remove both headlight assemblies. Refer to your vehicle
owners manual for the proper procedure for both.
2. The speaker bracket will mount to the side of the support brace (on
the passenger side) that is indicated in Figure 1 below.
3. Place the bracket onto the mounting area in the exact position it will
be mounted, then using the bracket as a template mark the 2
mounting holes off onto the mounting surface.
4. Secure the speaker to the mounting bracket. . An SA314 is shown.
See page 2 for an SA315.
5. Drill the 2 mounting holes using a drill bit sized for a 5/16 - 18 hex
head bolt and secure the bracket (with speaker) onto the mounting
area with the supplied mounting hardware.
6. Extend the WHITE (Positive) and BLACK (Negative) speaker wires to
your siren amplifier and connect as shown in the amplifiers
instructions.