Amprobe AT-5000 Underground-Wire-Tracer User Manual
Page 17
15
Push
•
Select to activate the desired setting. The transmitter automatically returns to the operational display screen.
My Preset State Menu
The T-5000 My Preset State allows the operator to return the transmitter’s operational conditions to the configured and saved
preset state by selecting – No or yes.
The My Preset State feature is configured using the three-button navigational keypad.
Push the left/right arrows to select the desired setting.
•
Push Select to activate the desired setting. The transmitter automatically returns to the operational display screen.
•
About T-5000 Menu
The About T-5000 menu allows the operator to view the transmitter’s serial number, hardware, and firmware information.
Push Menu to return to the previous screen.
•
Sheath fault Locating (SfL) optional Accessory A-5000
The Sheath Fault Locating (SFL) feature is available in Direct (Conductive) Connection mode only.
Push the SFL button,
•
, to activate operation.
Frequency selection is not configurable through the frequency menu screen.
Frequency selection: 9.82 kHz or 82 kHz, is activated by pressing the frequency button,
.
The active frequency is displayed on the operational display screen.