PLANET FGSD-910HP - Manual (Page 11)

11
100~240V AC
50/60Hz, 2.5A max.
Figure 2-4: FGSD-910HP Switch Rear Panel
Power
Notice
The device is a power-required device, meaning it will not work till
it is powered. If your networks should be active all the time, please
consider using UPS (Uninterrupted Power Supply) for your device.
It will prevent you from network data loss or network downtime.
In some area, installing a surge suppression device may also help
to protect your FGSD-910P / FGSD-910HP from being damaged by
unregulated surge or current to the FGSD-910P / FGSD-910HP or
the power adapter.
Before startup
Before your installation begins, please refer to the following for your cabling:
10/100Base-TX (Port 1 to Port 8)
All 10/100Base-TX ports come with Auto-Negotiation capability. They automatically
support 100Base-TX and 10Base-T networks. Users only need to plug a working
network device into one of the 10/100Base-TX ports, and then turn on the PoE
Ethernet Switch. The port will automatically run in 10Mbps, 20Mbps, 100Mbps or
200Mbps after negotiating with the connected device.
10/100/1000Base-T (Port 9)
The 10/100/1000Base-T port comes with Auto-Negotiation capability, which
automatically supports 1000Base-T, 100Base-TX and 10Base-T networks. Users
only need to plug a working network device into the 10/100/1000Base-T port, and
then turn on the PoE Ethernet Switch. The port will automatically run in 10Mbps,
20Mbps, 100Mbps or 200Mbps and 1000Mbps or 2000Mbps after negotiating with
the connected device.
Cabling
Each 10/100Base-TX and 10/100/1000Base-T port uses RJ-45 sockets -- similar
to phone jacks -- for connection of unshielded twisted-pair cable (UTP). The IEEE
802.3 / 802.3u / 802.3ab Fast / Gigabit Ethernet standard requires Category 5 UTP
for 100Mbps 100Base-TX. 10Base-T networks can use Cat.3, 4, 5 or 1000Base-T
uses 5/5e/6 UTP (see table below). Maximum distance is 100 meters (328 feet).