PLANET FT-1105A - Manual (Page 11)

8

NOTE:
It recommends using PLANET MFB-FX series
100Base-FX SFP on the converter. If you insert
a SFP transceiver that is not supported, the
converter will not recognize it.
Step 4: Connect the fiber cable. Attach the duplex LC connector on
the network cable into the SFP transceiver.
Step 5: Attach fiber cable from the FT-1105A/FT-1205A to the
fiber network. TX, RX must be paired at both ends.
Step 6: Connect the 5VDC power adapter to the FT-1105A/FT-
1205A and verify that the Power LED lights up.
Step 7: Turn on the power of the device/station; the PWR LEDs
should light when all cables are attached.

NOTE:
Please refer to APPENDIX-A for detailed wiring
information of the FT-1105A/FT-1205A.
To prevent from optic acceptor malfunction,
check the both wires / transmitter before power
on the converter.
6.2 Chassis Installation and Rack Mounting
To install the media converter in a 10-inch or 19-inch with standard
rack, follow the instructions described below.
Step 1: Place your FT-1105A/FT-1205A on a hard flat surface, with
the front panel positioned towards your front side.