PLANET FT-1105A - Manual (Page 12)

9
Step 2: Carefully slide in the module until it is fully and firmly
fitted into the slot of the chassis.
Figure 6-2: Insert a media converter into an available slot
Step 3: Attach a rack-mount bracket to each side of the Chassis
with supplied screws attached to the package.
Step 4: After the brackets are attached to the chassis, use suitable
screws to securely attach the brackets to the rack, as
shown in Figure 6-2.
Step 5: Proceed with the steps 4 and steps 5 of session 6.1 Stand-
alone Installation to connect the network cabling and
supply power to your switch.

Caution:
You must use the screws supplied with the mounting
brackets. Damage caused to the parts by using
incorrect screws would invalidate your warranty.