PLANET FT-1105A - Manual (Page 9)

6
Chapter 5
DIP SWITCH
There is a DIP switch for the setting on converter mode of copper
and fiber port. Refer to the table below for more details.
 FT-1105A
Switch 1 On 2-Port Redundant (TP)
Off 3-Port Switch ( default )
Switch 2 On LBR ON
Off LBR OFF ( default )
 2-Port Redundant ( FT-1105A)
When TP Redundancy is enabled, TP Port-2 and TP Port-3 are
configured as either forwarding or disabled. At any given time,
one port will be disabled and one port will be forwarding.
 3-Port Switch
When TP Redundancy is disabled, all ports (Port-1, Port-2 and
Port-3) act as normal bridging ports.
 LBR ( Loop Back Reply)
Enable/Disable the converter to reply for Loop Back Test.