PLANET WNRT-632 - Manual (Page 57)

2.3.4.4 SNMP
In brief, SNMP, the Simple Network Management Protocol, is a protocol designed to give a user the
capability to remotely manage a computer network by polling and setting terminal values and monitoring
network events.
Enable SNMP
You must check Local, Remote or both to enable SNMP function. If Local is checked, this device will
response request from LAN. If Remote is checked, this device will response request from WAN.
Get Community
Setting the community of GetRequest your device will response.
Set Community
Setting the community of SetRequest your device will accept.
IP 1, IP 2, IP 3, IP 4
Input your SNMP Management PC’s IP here. User has to configure to where this device should send
SNMP Trap message.
57