PLANET HDVR-1600 - Manual (Page 9)


• For Non-DHCP users, set the DHCP to <OFF>. IP address, Netmask, Gateway
and DNS settings must be set. Please obtain the information from the network
service provider.
• To change the IP address, Netmask, Gateway and DNS value, press UP/DOWN
keys to move the cursor to the item. Use LEFT/RIGHT keys to access each
section of the value and press ENTER, then change the value using UP/DOWN
keys.
• PPPoE users must set the <PPPoE Account>, <PPPoE Password> and
<PPPoE Max Idle> as well.
• When the settings are complete, press ENTER to confirm and save the settings;
or ESC to abort.
Dome Camera Control
Dome Camera Connection & Settings:
• See section Pin Definition of Alarm I/O & RS-485 for RS-485 port pin definition.
• Refer to the following figure. Connect the R+, R− terminals on the dome camera
to the D+, D− terminals on the RS-485 port by RS-485 cable respectively.
• To set up dome camera’s protocol and ID, press MENU to access the OSD main
menu, and select <Camera Setup>. The available protocols include <DSCP>,
<Pelco D>, <Pelco P>, <AD422>, <Fastrax 2>, <JVC>, <Panasonic_
C>, and <Panasonic_N>. The default is <None>. Note that ID number must
match the ID address defined by the dome camera.
• To configure the RS-485 parameters, select <System Setup> from OSD main
menu, and then select <RS485 Setup>. The default RS-485 settings are ID
224, 9600 Baud, 8 Data Bits, 1 Stop Bit and No Parity.