ProSoft Technology AN-X2-SQD - Manual (Page 18)

Page 12 AN-X2-SQD-MAS June 2013
Example: DHCP
IP: DHCP
Hostname: ANX2SqdMas
Firmware: AN-X2-SQD-MAS
Example: static IP address
IP: 192.168.1.14
NetMask: 255.255.255.0
DefGtwy: 192.168.1.1
HostName: ANX2SqdMas
Firmware: AN-X2-SQD-MAS
If the link-local address is not accessible…
Addresses 169.254.1.0 to 169.254.254.255 are reserved for use on a local network.
AN-X2 modules are shipped set to the address 169.254.42.84 for initial configuration.
This address is almost always accessible from a computer on the same local Ethernet as
the AN-X.
If you cannot access the AN-X2 at address 169.254.42.84 using a web browser, open a
command prompt window and type
route print
The routing table appears
===========================================================================
Interface List
0x1 ........................... MS TCP Loopback interface
0x2 ...00 18 8b c5 9d f7 ...... Broadcom 440x 10/100 Integrated Controller -
Packet Scheduler Miniport
===========================================================================
===========================================================================
Active Routes:
Network Destination Netmask Gateway Interface Metric
0.0.0.0 0.0.0.0 10.10.0.1 10.10.0.20 20
10.10.0.0 255.255.255.0 10.10.0.20 10.10.0.20 20
10.10.0.20 255.255.255.255 127.0.0.1 127.0.0.1 20
10.255.255.255 255.255.255.255 10.10.0.20 10.10.0.20 20
64.215.255.122 255.255.255.255 10.10.0.1 10.10.0.20 20
127.0.0.0 255.0.0.0 127.0.0.1 127.0.0.1 1
169.254.0.0 255.255.0.0 10.10.0.20 10.10.0.20 20
224.0.0.0 240.0.0.0 10.10.0.20 10.10.0.20 20
255.255.255.255 255.255.255.255 10.10.0.20 10.10.0.20 1