ProSoft Technology AN-X2-SQD - Manual (Page 41)

AN-X2-SQD-MAS Page 35
The top of the screen shows the serial number and MAC Address of the AN-X2 being
configured.
Check either DHCP or Static.
DHCP
If the AN-X2 finds a DHCP server on the network, it obtains an IP address and other
network parameters (netmask and default gateway) from the DHCP server.
To find the address assigned, you have to look at DHCP server.
When you submit the changes, if the AN-X2 does not find a DHCP server, it reverts to
the default link local address 169.254.42.84 and repeatedly flashes the SYS (or MS) LED
3 times red followed by a pause.
Static IP Address
If you select static IP address, enter:
• the IP address for the AN-X.
• the netmask for the AN-X
• the default gateway for your network.
You must enter a valid default gateway address even if there is no device at the gateway
address on the network.
Hostname
Enter a Hostname for the AN-X2. This name is used internally by AN-X and may be
used to identify the AN-X if you have a DNS server on your network. The name can be
from 1 to 30 characters long
Firmware
Select the firmware the AN-X is to load from the list provided. AN-X builds the list from
the firmware files on the microSD card that are compatible with the AN-X hardware.
Submitting the Configuration
Once you have entered all required parameters, click SUBMIT to write the configuration
to the file config.txt on the microSD card. The changes do not take effect until the AN-X
restarts.
Archive Configuration
Use Archive Configuration to create an archive that contains the current AN-X
configuration and logs, for use by technical support.