JVC DLA-Z1 - Manual (Page 24)

Viewing Videos
MEMO
0
Make sure to remove the lens cover.
0
Connect the power cord, and ensure that the “STANDBY/ON” indicator
lights up in red.
0
During standby in the “ECO Mode”, the “STANDBY/ON” indicator does
not light up even when the power cord is correctly connected.
In this case, cancel the standby mode by pressing any button on the
remote control unit, or use the A button on the projector unit when you
are turning on the power.
1 Turn on the power
Remote control: press the C [ON] button
Projector unit: press the A button
0
The “STANDBY/ON” indicator light switches from red (light off in
“ECO Mode”) to green (light goes off after the unit starts up).
.
LIGHT WARNING STANDBY/ON LIGHT WARNING STANDBY/ON LIGHT WARNING STANDBY/ON DB AN BY/O DB AN BY/O
When in “ECO Mode”
“STANDBY/ON” light off
When LD block is starting up
“STANDBY/ON” lights up (green)
In standby state
“STANDBY/ON” lights up (red)
2 Choose the image to project
Remote control: press the [HDMI 1] or [HDMI 2] button
Projector unit: press the [INPUT] button to switch the input
0
Play back the selected device to project the image.
To hide the image temporarily
Press the [HIDE] button on the remote control
0
The “STANDBY/ON” indicator light starts to blink in green.
0
Press the [HIDE] button again to resume display of the image.
0
The power cannot be turned off when the image is temporarily hidden.
STANDBY/ON LIGHT
WARNING
SETTING MEMORY
MODE 1 MODE 2 MODE 3
1
1 3 2
2
3
This unit
Remote Control
24
Operate