JVC DLA-Z1 - Manual (Page 25)

3 Turn off the power
Remote control: press the B [STAND BY] button
Projector unit: press the A button
0
While the “Are you sure you want to turn off?” message is displayed, press the button again.
0
The light of the LD block goes off, and the “STANDBY/ON” indicator switches from a green light to a red blinking
light.
0
After the light goes off, the fan will run for about 10 seconds to cool down the LD block (Cool-down mode). Do
not disconnect the power cable while cooling is in progress.
0
After about 10 seconds, the “STANDBY/ON” indicator switches from a blinking red to a solid red light.
.
LIGHT WARNING STANDBY/ON DB TAN Y/O LIGHT WARNING STANDBY/ON DB
In standby state
“STANDBY/ON” lights up (red)
In the Cool-down mode
“STANDBY/ON” blinking (red)
0
Attach the lens cover.
CAUTION
0
The power cannot be turned off within approximately 30 seconds after it has been turned on.
0
The power cannot be turned on again while cooling is in progress (10 seconds).
0
Pull out the power plug when the unit is not to be used for a prolonged period of time.
0
If the indication of indicator differs from the description, refer to “Indicator Display on the Main Unit”P. 75 for details.
25
Operate