Nikon D5500 - Manual (Page 418)

394 Technical Notes
❚❚ Vibration Reduction (VR)
Vibration reduction can be enabled by sliding the
vibration reduction switch to ON and takes effect
whenever the shutter-release button is pressed
halfway. Vibration reduction reduces blur caused
by camera shake, allowing shutter speeds up to 4.0
stops slower than would otherwise be the case and increasing
the range of shutter speeds available. The effects of VR on
shutter speed are measured according to Camera and Imaging
Products Association (CIPA) standards; FX-format lenses are
measured using FX-format digital cameras, DX-format lenses
using DX-format cameras. Zoom lenses are measured at
maximum zoom.
D Vibration Reduction
• When using vibration reduction, press the shutter-release button
halfway and wait for the image in the viewfinder to stabilize before
pressing the shutter-release button the rest of the way down.
• When vibration reduction is active, the image in the viewfinder may
jiggle after the shutter is released. This does not indicate a
malfunction.
• When the camera is panned, vibration reduction applies only to
motion that is not part of the pan (if the camera is panned
horizontally, for example, vibration reduction will be applied only to
vertical shake), making it much easier to pan the camera smoothly in
a wide arc.
• Do not turn the camera off or remove the lens while vibration
reduction is in effect.
• If the camera is equipped with a built-in flash, vibration reduction will
be disabled while the flash charges.
• Select OFF when the camera is mounted on a tripod unless the tripod
head is unsecured or the camera is mounted on a monopod, in which
case ON is recommended.