Roland AIRA TR-6S Rhythm Performer - Manual (Page 15)

15
Recording Knob Movements at Steps
(Motion)
Recording/Playing MOTION
When “INST REC” is “ON,” movements of the instrument’s [TUNE] knob,
[DECAY] knob, and [CTRL] knob are recorded in the steps.
If you hold down the [SHIFT] button and press the [VARIATION] button
to turn MOTION “ON,” the recorded knob movements are played.
* REVERB LEVEL, DELAY LEVEL, MASTER FX CTRL, and MASTER FX ON are
also recorded/played according to the MOTION status.
MOTION setting
1 Hold down the [SHIFT] button and press the
[VARIATION] button.
2 Use the [VALUE] knob to select “ON ”
Select “OFF” if you don’t want to record or play back motion data.
3 Press the [EXIT] button.
Entering a value at a specified step
While the [TR-REC] button is lit, you can specify a step and enter a
value for a knob.
1 Operate a knob while holding down a pad [1] – [16] .
MEMO
Alternatively, you can hold down a pad [1]–[16] and use the
[UTILITY] (+) button and [COPY] (-) button to select the parameter
that you want to enter, and then use the [VALUE] knob to make
adjustments.
Clearing Motion Data of a Selected Target
1 While holding down the [SHIFT] button and the
[VARIATION] button, turn the [VALUE] knob to
select the target for deletion, and then press the
[VALUE] knob.
When you release your hand from the buttons, you return to the
previous screen.
Target to clear Explanation
ALL All motion data is cleared.
VARIATION A–H Variation motion data is cleared.
FILL IN 1, 2 FILL IN 1 and 2 motion data is cleared.
REVERB LEVEL REVERB LEVEL motion data is cleared.
DELAY LEVEL DELAY LEVEL motion data is cleared.
DELAY TIME DELAY TIME motion data is cleared.
DELAY FEEDBACK DELAY FEEDBACK motion data is cleared.
MASTER SW MASTER SW motion data is cleared.
MASTER CTRL MASTER CTRL motion data is cleared.
Clearing motion data for only a specific knob
This clears all motion data of a knob recorded in the track that’s
specified by the variation selected for playback.
1 While holding down the [SHIFT] button and the
[VARIATION] button, operate the knob.
Clearing motion data for a specific step
While the [TR-REC] button is lit, you can specify a step and clear the
knob values.
1 Long-press the pad [1] – [16] whose step contains the
motion data that you want to clear.
The MOTION/VELOCITY input screen appears.
2 While holding down the pad that you pressed in
step 1, press the [COPY] or [UTILITY] button to
select the motion that you want to clear.
* If the selected step (pad) does not contain motion data, “----” is shown as
the value.
* In this state, you can also turn the [VALUE] knob to input motion data.
3 While holding down the pad that you pressed in
step 1, press the [CLEAR] button.
Clearing the motion data of the specified step (pad).