DJI Mini 2 SE Fly More Combo Drone - Manual (Page 27)

26 © 2023 DJI All Rights Reserved.
DJI MINI 2 SE User Manual
A gimbal motor error may occur in the following situations: a. The aircraft is on uneven ground or the
gimbal is obstructed. b. The gimbal experiences excessive external force, such as during a collision.
DO NOT apply external force to the gimbal after the gimbal is powered on. DO NOT add any extra
payload to the gimbal as this may cause the gimbal to function abnormally or even lead to permanent
motor damage.
Make sure to remove the gimbal protector before powering on the aircraft. Also, make sure to mount
the gimbal protector when the aircraft is not in use.
Flying in heavy fog or clouds may make the gimbal wet, leading to temporary failure. The gimbal
recovers full functionality once it is dry.
Camera Profile
DJI Mini 2 SE uses a 1/2.3" CMOS sensor camera, which can shoot up to 2.7K video and 12MP
photos, and supports shooting modes such as Single, AEB, Timed Shot, and Panorama.
The aperture of the camera is F2.8 and can shoot at 1 m to infinity.
Make sure the temperature and humidity is suitable for the camera during usage and storage.
Use a lens cleanser to clean the lens to avoid damage.
DO NOT block any ventilation holes on the camera as the heat generated may damage the device
and hurt the user.
Storing Photos and Videos
DJI Mini 2 SE supports the use of a microSD card to store your photos and videos. A UHS-I Speed
Grade 3 rating or above microSD card is required due to the fast read and write speeds necessary for
high-resolution video data. Refer to the Specifications section for more information about recommended
microSD cards.
Without a microSD card inserted, users can still capture single photos or record 720p normal videos.
The file will be directly stored on the mobile device.
Do not remove the microSD card from the aircraft while it is powered on. Otherwise, the microSD
card may be damaged.
To ensure the stability of the camera system, single video recordings are limited to 30 minutes.
Check camera settings before use to make sure the configurations are correct.
Before shooting important photos or videos, shoot a few images to test the camera is operating
correctly.
Photos or videos cannot be transmitted from the microSD card in the aircraft using DJI Fly if the
aircraft is powered off.
Make sure to power off the aircraft correctly. Otherwise, the camera parameters will not be saved
and any recorded videos may be damaged. DJI is not responsible for any failure of an image or video
to be recorded or having been recorded in a way that is not machine-readable.
Download Photos and Videos
1. Make sure that the aircraft is connected to the mobile device via the remote controller and taht the
motors have not started.
2. Launch DJI Fly, enter playback, and tap in the upper left corner to access the files to download.