DJI Mini 2 SE Fly More Combo Drone - Manual (Page 52)

© 2023 DJI All Rights Reserved. 51
DJI MINI 2 SE User Manual
Updating Firmware
When you connect the aircraft or remote controller to DJI Fly, you will be notified if a new firmware update
is available. To update, connect the mobile device to the internet and follow the on-screen instructions.
Note that the firmware cannot be updated if the remote controller is not linked to the aircraft.
Make sure to follow all the steps to update firmware. Otherwise, the update may fail. The aircraft will
power off automatically after the firmware update is complete.
The firmware update will take approx. 10 minutes. It is normal for the gimbal to go limp, aircraft
status indicators to blink, and the aircraft to reboot. Wait patiently until the update is complete.
Before performing an update, make sure the Intelligent Flight Battery is at least 15% charged and the
remote controller is at least 20% charged.
The remote controller may become unlinked from the aircraft after updating. Relink the remote
controller and aircraft. Note that the update may reset various main controller settings, such as the
RTH altitude and the maximum flight distance, to default settings. Before updating, take note of your
preferred DJI Fly settings and readjust them after the update.
After-Sales Information
Visit https://www.dji.com/support to learn more about after-sales service policies, repair services, and
support.
Maintenance Instructions
To avoid serious injury to children and animals, observe the following rule:
1. Small parts, such as cables and straps, are dangerous if swallowed. Keep all parts out of reach of
children and animals.
2. Store the Intelligent Flight Battery and remote controller in a cool, dry place away from direct sunlight
to ensure the built-in LiPo battery does NOT overheat. Recommended storage temperature:
between 22° and 28° C (71° and 82° F) for storage periods of more than three months. Never store
in environments outside the temperature range of -10° to 45° C (14° to 113° F).
3. DO NOT allow the camera to come into contact with or become immersed in water or other liquids.
If it gets wet, wipe it with a dry soft, absorbent cloth. Turning on an aircraft that has fallen into water
may cause permanent component damage. DO NOT use substances containing alcohol, benzene,
thinners or other flammable substances to clean or maintain the camera. DO NOT store the camera
in humid or dusty areas.
4. DO NOT connect this product to any USB interface that is older than version 3.0. DO NOT connect
this product to any "power USB" or similar devices.
5. Check every part of the aircraft after any crash or violent impact. If you have any problems or
questions, please contact a DJI authorized dealer.
6. Regularly check the Battery Level Indicators to see the current battery level and overall battery life.
The battery is rated for 200 cycles. It is not recommended to continue use afterward.