EMI WLHA - Manual (Page 26)

www.enviromaster.com WLCA/WLHA High Wall Evaporator 26
Table #2
proGrAmminG sCHEdULE
m
onday
t
uesday
W
ednesday
t
hursday f
riday
s
aturday
s
unday
T
ime
Temp T
ime
Temp T
ime
Temp T
ime
Temp T
ime
Temp T
ime
Temp T
ime
Temp
Morning
Cool
Heat
: : : : : : :
Auto
Day
Cool
Heat : : : : : : :
Auto
Evening
Cool
Heat
: : : : : : :
Auto
Night
Cool
Heat
: : : : : : :
Auto
To copy the settings from any day to the entire week:
1) Select the day to be copied.
2) Simultaneously press the “FAN” and “PROg” buttons for three seconds.
optionAL HAnd HELd ControLLEr proGrAmminG
initiAL stArt-Up
WLCA/WLHA prEpErAtion
for stArt-Up
• Remove any tools or other obstructions
• Be sure the filter is in place
• Verify that the unit is level
• Separate any lines that contact each other
• Replace the cabinet end cap and the
grille front of the unit
Test each power and circuit connec-
tion before powering up the system. Use
the unit mounted electronic thermostat con-
trols to start the system. (Refer to the Initial
Operation of the unit depends on the room temperature. It may be necessary to warm
the room before testing the unit’s cooling abilities.
Start-Up and the operating instructions in
Control Operation Section, thermostat,
unit m
ount or remote.)
note: Check the outdoor unit’s start-
up instructions for specific require-
ments and procedures.