Denon AVR-A1H 15.4-Channel Network A/V Receiver - Manual (Page 236)

o ZONE2/3
When “Amp Assign” is “13.1ch + ZONE2/3-MONO”, the speaker
terminal used for the ZONE2/3 speakers is displayed. Depending on
the settings of Main Zone speaker configuration, the terminal is
determined automatically.
HEIGHT 3:
The HEIGHT 3 speaker terminal is used
for the ZONE2/3 speakers.
FRONT WIDE:
The FRONT WIDE speaker terminal is
used for the ZONE2/3 speakers.
SURROUND BACK:
The SURROUND BACK speaker
terminal is used for the ZONE2/3
speakers.
o Settings
Select the signal to be output from the selected speaker terminal.
0
Only “Center” and “None” can be set for the CENTER speaker
terminal.
0
If you are using a total of seven or more Height/Ceiling/Dolby Atmos
Enabled speakers, you can only set “Top Middle”, “Surround Dolby”,
or “None” for the HEIGHT 3 speaker terminal.
0
You can use the HEIGHT 4 speaker terminal only if you are using a
total of seven or more Height/Ceiling/Dolby Atmos Enabled
speakers. You can only set “Top Surround”, “Center Height”,
“TS/CH”, or “None” for the HEIGHT 4 speaker terminal.
o View Terminal Config.
This shows how to connect the speaker terminals and PRE OUT
connectors for your “Amp Assign” setting on the menu screen.
Contents Connections Playback Settings Tips Appendix
236
Front panel Display Rear panel Remote Index