Denon AVR-A1H 15.4-Channel Network A/V Receiver User Manual
Page 28
Advertising
Q4
Q3
Q2
Q1
K
RS-232C connector
Used to connect home automation controller devices fitted with
RS-232C connectors. Consult the owner’s manual of the home
automation controller for more information about serial control of this
unit.
Perform the operation below beforehand.
A
Turn on the power of this unit.
B
Turn off the power of this unit from the external controller.
C
Check that the unit is in the standby mode.
L
AC inlet (AC IN)
Used to connect the power cord. (
M
SIGNAL GND terminal
Used to connect a ground wire for the turntable. (
N
Speaker terminals (SPEAKERS)
Used to connect speakers. (
NOTE
0
Do not touch the inner pins of the connectors on the rear panel. Electrostatic
discharge may cause permanent damage to the unit.
28
Advertising