Epson EM07ZS1647F - Manual (Page 30)

2. Installation
(7) Tighten each screw securing the wires on the connector.
Tighten the screw securing the wire at a correct tightening torque (0.25 to 0.3 N·m). To
prevent thick cable from coming out due to cable tension, install enough thick cable
length to allow for stretch.
Use a small flat blade screwdriver that has the correct
width and thickness. If you use a typical screwdriver
whose point is narrow, you cannot deeply insert it into
the hole on the connector.
Specific screwdriver for DeviceNet connector screw:
OMRON : XW4Z-00C
Phoenix Contact : SZF-1 0.6 ×3.5
Thickness Width
0.6 mm 3.5 mm
18 Fieldbus I/O Rev.6