Epson EM07ZS1647F - Manual (Page 96)

4. Troubleshooting (DeviceNet)
♦ Process Flowchart
Replace the unit.
2
† No Problem
Check
Check the following:
- Unconnected terminating resistor
- Unconnected or loose connector/signal wire
- Cable disconnection
3 4
Finish
Divide the network and
find the trouble unit.
† No Problem
† No Change
† No Change
† No Change
† The trouble unit is not found.
Rarely
Problem exists. (Fix it.)
No change
No change
No change
Immediately
The unit is not found.
The unit is found.
Yes
Problem exits. (Fix it.)
The problem is fixed.
The problem is fixed.
The problem is fixed.
No
See 4.1.3.1 and 4.1.3.2.
See 4.1.3.3.
No problem
No problem
Replace the trouble unit.
Check for noise influence.
Does an error occur immediately?
Normal Communication?
„ Analyze the network with NetMeter.
„ Consult the DeviceNet manufacturer.
Measure voltage of
communications power supply.
Replace moving cable
(Replace deteriorated cable).
84 Fieldbus I/O Rev.6