Epson EM07ZS1647F - Manual (Page 70)

2. Installation
(8) The following dialog will appear.
Check that “PCI/PCU-ETHIO (“PCI-DVNIO” in case of DeviceNet, and ”“PCI-
DPIO” or “PCU-DPIO” in case of PROFIBUS-DP) is shown in the Board Type:
box. Then, click the OK button.
When installing more than two fieldbus boards in the system, add all the boards
using this dialog.
The following dialog will appear when no board is detected. Ensure that the board is
correctly inserted and that the board configuration is correct.
(9) Click the OK button. The following dialog will appear.
Select EtherNet/IP from Protocol, and click the OK button.
58 Fieldbus I/O Rev.6