Epson 811p - Manual (Page 94)

88 Appendix A: Connecting to Additional Equipment
Connecting to a Desktop Macintosh
You can connect the projector to any desktop Macintosh. This section
includes instructions for the following:
■ Connecting the computer cable
■ Connecting the mouse cable (if you want to use your remote
control as a mouse or use USB audio)
■ Connecting the audio cable (if you’ll be projecting with audio)
Follow the steps in each section for the cables you need to connect.
Before beginning, make sure the projector and computer are turned
off. If you need help with positioning the projector, see page 10.
Connecting the Computer Cable
1. Disconnect the monitor cable from the video port on the back of
the Macintosh.
2. If you’ll be viewing the display on your computer monitor as well
as the projector screen, connect the monitor cable to the
projector’s
Monitor Out port, as shown.
note
Macintosh configurations
vary. See your computer
manual for the location of the
ports needed to connect your
projector. Older models may
require a Macintosh adapter
set, which you may purchase
from EPSON; see page 7.
Monitor
Out port
600-811-820.book Page 88 Tuesday, April 30, 2002 10:17 AM