Heat & Glo Fireplace 6000 XLT - Manual (Page 38)

35
Positioning the Logs
If the gas logs have been factory installed they should
not need to be positioned.
If the logs have been packaged separately, refer to the
installation instructions that accompany the logs.
Save the log instructions with this manual.
If sooting occurs, the logs might need to be
repositioned slightly to avoid excessive flame
impingement.
Placing the Ember Material
Two separate bags of ember material are shipped with
this gas fireplace:
• The bag labeled Golden Ember (GE-93) is flame
colorant material.
• The bag labeled Glowing Ember (050-721) is
standard glowing ember material.
To place the ember material:
• Remove the wing nuts and glass clips or tension
springs around the glass door.
• Remove the glass door from the unit.
• Cover the top of the burner with a single layer of
ember material. Then sprinkle GE-93 on top of the
burner.
• Save the remaining ember materials for use during
fireplace servicing.
• Replace the glass door and a front trim door on the
unit (see Replacement Parts Section of the
manual.)
• Replace the wing nut, glass clips, and tension
springs.
• Hand tighten the wing nuts.