Setting unit for cvbs (svhs) or vga output, Figure 2-5, Cvbs (svhs) vga switch – Honeywell HRHD 410 User Manual
Page 26
Advertising
Installation
Rev 3.01
8
Document 900.0315
10/05
Setting Unit for CVBS (SVHS) or VGA Output
Figure 2-5
CVBS (SVHS) VGA Switch
Set the switch to CVBS (SVHS) or VGA for monitor output. Select CVBS (SVHS) for a
spot monitor or VGA for an RGB monitor.
Make sure you set the CVBS (SVHS) or VGA selector switch before turning on the
DVR. You cannot change the setting while the unit is running.
Note
The DVR may not support some LCD monitors. Also, some
monitors do not support Multi Sync.
Note
You cannot use the spot monitor and VGA outputs at the same
time.
VGA
CVBS
SVHS
Advertising