Connecting the monitor, Connecting the spot monitor, Connecting the rgb monitor – Honeywell HRHD 410 User Manual
Page 27: Figure 2-6, Video out connectors, Figure 2-7, Vga connector
Advertising
Installation
Rev 3.01
9
Document 900.0315
10/05
Connecting the Monitor
Connecting the Spot Monitor
Figure 2-6
Video Out Connectors
Connect the Spot Monitor to either the Video Out or SVHS Out connector.
Note
For Spot Monitor output, set the CVBS (SVHS) VGA selector to
CVBS (SVHS) (see
). If your monitor has an SVHS
input, use it to give you better quality video display.
Note
The Video Out (BNC) and the SVHS Out connectors may be
connected to individual monitors for simultaneous operation.
Connecting the RGB Monitor
Figure 2-7
VGA Connector
Use the VGA port for RGB Monitor output. Connect the RGB Monitor to the VGA
connector. Connect an RGB cable with a DB15 (Male) connector which is usually less
than 10 feet (3 m) to the DVR connector.
SVHS OUT
VIDEO OUT
VGA
Advertising