Honeywell HRHD 410 - Manual (Page 43)

Configuration
Rev 3.01 25 Document 900.0315
10/05
Note You can upgrade the software only in the System Information
Change screen.
Only the System Administrator can upgrade the software.
You cannot upgrade the software during clip copy.
To upgrade the software:
a. Connect the USB device containing the upgrade package file to the DVR.
Highlight Upgrade… and press # . The System Upgrade screen displays
showing the upgrade package file name.
Note If no hard disk drives are installed in the DVR, the Upgrade…
button will be disabled.
Note If the file system on the USB -IDE hard disk drive or USB flash
drive is not FAT16 or FAT32 format, format the device using
FAT16 or FAT32 format.
b. Select Start and then enter the Admin password to start the upgrade.
c. The system restarts automatically after the upgrade is complete. The software
starts running after restarting the unit.
7. You can save your changes by highlighting OK and pressing # . Selecting Cancel
exits the screen without saving the changes.