Home Dynamix HP-51M - Manual (Page 14)

DYNAMIX HP-51M Coax MDU Master Bridge User’s Guide
8
Each row represents for one EP, here we have one Master (Local) HCNA device (on the top) and 7 extra Slave EP
devices shown on the window. The first two are EPs based on 3010, follows three Smart EPs based on 3110 (or
called Configurable EPs), and the last two EPs that are powered off.
Smart EP
Denote an EP whose Ethernet properties are configurable. Based on 3110 chipset, with built-in simple management
function, its Ethernet settings can be configured by HP-51M. Refer “
Master/EP Ethernet Properties ”. In contrast to
Smart EP, EP based on 3010 chipset will not be denoted as ‘Smart’ and is not configurable in its Ethernet properties.
For each shown column,
Sel : click on ‘ Sel ’ button will select all listed on-line EPs at once for EP HCNA driver upgrade, or just
designate the EP one by one for EP HCNA driver upgrade. The top row is the Master device (denoted
‘Local’ in field Note).
Link : light for HCNA device current connection status.
Green:EP is active -- on-line. For Master device, green always.
Gray: EP is not active -- off-line, either user powers it off or cabling has trouble. (‘NA’ means value Not
Applicable/Available since setting value in this field is stored inside EP and the EP is unreachable
now.)
MAC : HCNA MAC address.
F/W : the current queried working (running) HCNA driver version
Model : the current queried working HCNA model name
Note : used to denote EP end-user, for recording username or address or specific message. Mark ‘Local’ for
Master HCNA device.